Zoom

Round Base Retrofit Flashing

simple solution to flashing a penetration through a metal roof that requires a wrap-around installation
wraps easily around existing or hard to reach penetrations
has clearly marked diameters on each flashing
marked dimensions also allow for easy sizing to fit each individual application
snaps together in seconds and does not require any special tools or accessories
resistant to ultraviolet rays, cracking & weathering.
the aluminum base on the upper lip is corrosion resistant and allows the flashing to conform to any panel configuration and/or roof pitch.

Starting At:

Item #	Description/Size	Availability	Qty Break	Price
MBARF0200	#1 Retrofit Round Base Flashing \| Fits Pipe Sizes ¾" to 2¾"	In Stock	1	$20.53
MBARF0205	#2 Retrofit Round Base Flashing \| Fits Pipe Sizes 2" to 7¼"	In Stock	1	$34.67
MBARF0210	#3 Retrofit Round Base Flashing \| Fits Pipe Sizes 3¼" to 10"	In Stock	1	$53.32

Test Type	Specification	Test Results
Tensile Strength (min. psi rating)	1,450 psi min.	1,537 psi
Ultimate Elongation (%)	350 min.	535
Resistance to Ozone (min. rating)	100 (no cracks)	Passed
Heat Aging-70 hrs. at 212ºF Change in Hardness (points) Change in Tensile Strength (%) Change in Elongation (%)	15 +/- max. 30 +/- max. 50 +/- max.	8+ 4.7+ 26-
Low Temperature Brittleness-3 mins. at 40ºF	Non-Brittle	Passed
Tear Resistance Die C (min.) per inch of width min.	125 pounds per inch of width	130 pounds
Flame Resistance	U.L. 94 H.B.	Passed

1.	Begin cutting opposite of the mechanical locking joiner. Cut through the joiner with tin snips
2.	Wrap the flashing around the pipe. Engage the top section of the joiner first, then proceed down until the joiner is completely engaged.
3.	Crimp joiner tightly, starting at the top by squeezing the joiner "fingers" with pliers.
4.	Apply sealant to the underside of the ribbed aluminum base. Press the pipe boot against contours of the panel configuration.
5.	Attach the flashing to the panel with self-drilling screws. Screws should be spaced as necessary to avoid gaps between the base and the panel.
6.	Apply additional sealant around the top of the pipe boot & along the mechanical joiner seam.