SKU
MBASMP

Solar Multi-Port Square Base Flashing

ACCOMMODATES:
•one - 0" to 2" pipe
•two - 3/8" pipe/cable
•two - 3/4" pipe/cable   DETAILS:
•allows for up to 4 cables or wires per flashing
•extra ports accommodate copper pipe & electrical cables 
•easy...
Read More
$19.40
 

ACCOMMODATES:

  • one - 0" to 2" pipe
  • two - 3/8" pipe/cable
  • two - 3/4" pipe/cable

 

DETAILS:

  • allows for up to 4 cables or wires per flashing
  • extra ports accommodate copper pipe & electrical cables 
  • easy installation for solar applications



MATERIAL SPECIFICATION:

TEST TYPE EPDM SILICONE
Advance ozone resistance test @500 pphm 70 hours 70 hours
High Temperature:
intermittent-
continuous-
+275ºF
+212ºF
+500ºF
+437ºF
Low Temperature:
resistance tested to-
tensile strength-
-65ºF
1,450 psi
-100ºF
700 psi

 



INSTALLATION INSTRUCTIONS:

  1. cut to approximately 20% smaller than the diameter of the penetration
  2. slide the flashing down the penetration, using water to lubricate if necessary
  3. form & bend the aluminum base of the flashing to fit the surface of the roof
  4. seal the flashing by applying urethane/silicone sealant between the flashing & the roof 
  5. use a large slot screwdriver to press the base down tightly
  6. fasten the flashing with weather-resistant fasteners to complete the seal

 




TECHNICAL DATA:

Five-Port Square Base Flashing Specification Sheet

TEST TYPE EPDM SILICONE
Advance ozone resistance test
@ 500 pphm
70
Hours
70
Hours
High Temperature:
Intermittent-
Continuous-
+275ºF
+212ºF
+500ºF
+437ºF
Low Temperature:
Resistance tested to-
Tensile strength-
-65ºF
1,450 psi
-100ºF
700 psi
1. Cut to approximately 20% smaller than the diameter of the penetration.
2. Slide the flashing down the penetration, using water to lubricate if necessary.
3. Form & bend the aluminum base of the flashing to fit the surface of the roof.
4. Seal the flashing by applying urethane/silicone sealant between the flashing & the roof.  Use a large slot screwdriver to press the base down tightly.
5. Fasten the flashing with weather-resistant fasteners to complete the seal.