Retrofit Dektite®-Round Base Retrofit Flashing

Home > Retrofit Dektite-Round Base Retrofit Flashing >

Zoom

Retrofit Dektite®-Round Base Retrofit Flashing

The Retrofit Dektite® is a simple solution to flashing a penetration through a metal roof that requires a wrap-around installation.

The Retrofit Dektite® wraps easily around existing or hard to reach penetrations.

The clearly marked diameters on each flashing allow the Retrofit Dektite® to accommodate a range of sizes. The marked dimensions also allow for easy sizing to fit each individual application.

The Retrofit Dektite® snaps together in seconds and does not require any special tools or accessories. Available in gray EPDM, a flexible material, the Retrofit Dektite® is resistant to ultraviolet rays, cracking & weathering.

The aluminum base on the upper lip of the Retrofit Dektite® is corrosion resistant and allows the flashing to conform to any panel configuration and/or roof pitch.

Item #	Description/Size	Availability	Qty Break	Price
MBARF0100	#801 Retrofit Dektite-Gray EPDM \| Fits Pipe Sizes ¾" to 2 ¾"	In Stock	1	$28.69
MBARF0105	#802 Retrofit Dektite-Gray EPDM \| Fits Pipe Sizes 2" to 7 ¼"	In Stock	1	$55.77
MBARF0110	#803 Retrofit Dektite-Gray EPDM \| Fits Pipe Sizes 3 ¼" to 10"	In Stock	1	$77.32

Material Specifications
Installation Instructions

Test Type	Specification	Test Results
Tensile Strength (min. psi rating)	1,450 psi min.	1,537 psi
Ultimate Elongation (%)	350 min.	535
Resistance to Ozone (min. rating)	100 (no cracks)	Passed
Heat Aging-70 hrs. at 212ºF Change in Hardness (points) Change in Tensile Strength (%) Change in Elongation (%)	15 +/- max. 30 +/- max. 50 +/- max.	8+ 4.7+ 26-
Low Temperature Brittleness-3 mins. at 40ºF	Non-Brittle	Passed
Tear Resistance Die C (min.) per inch of width min.	125 pounds per inch of width	130 pounds
Flame Resistance	U.L. 94 H.B.	Passed

1.	Begin cutting opposite of the mechanical locking joiner. Cut through the joiner with tin snips
2.	Wrap the Retrofit Dektite® around the pipe. Engage the top section of the joiner first, then proceed down until the joiner is completely engaged.
3.	Crimp joiner tightly, starting at the top by squeezing the joiner "fingers" with pliers.
4.	Apply sealant to the underside of the ribbed aluminum base. Press the Retrofit Dektite® against contours of the panel configuration.
5.	Attach the Retrofit Dektite® to the panel with self-drilling screws. Screws should be spaced as necessary to avoid gaps between the base and the panel.
6.	Apply additional sealant around the top of the Dektite® & along the mechanical joiner seam.