Middy® Two-Port Square Base Flashing

Item #:

Specifications

  • accommodates:
    • one - 0" to 2" pipe (center port)
    • one- 3/8" pipe/cable (side port)
  • easy installation
Price: $8.82
    Price as configured

    Product Options

    Material:


    Update price
    Quantity:

    TEST TYPE EPDM SILICONE
    Advance ozone resistance test
    @ 500 pphm
    70
    Hours
    70
    Hours
    High Temperature:
    Intermittent-
    Continuous-
    +275ºF
    +212ºF
    +500ºF
    +437ºF
    Low Temperature:
    Resistance tested to-
    Tensile strength-
    -65ºF
    1,450 psi
    -100ºF
    700 psi

    1. Cut to approximately 20% smaller than the diameter of the penetration.
    2. Slide the flashing down the penetration, using water to lubricate if necessary.
    3. Form & bend the aluminum base of the flashing to fit the surface of the roof.
    4. Seal the flashing by applying urethane/silicone sealant between the flashing & the roof. Use a large slot screwdriver to press the base down tightly.
    5. Fasten the flashing with weather-resistant fasteners to complete the seal.

    Product Reviews

    Related Items: